Home page

Pengxu membrane application solution recommendation

Time:

2025-04-14

Targeting PVC wear layers with a thickness of 0.07-0.7mm, and incorporating an anti-plasticizer migration feature to prevent water-based floor adhesive degradation. The structural design is as follows:

1. For PVC wear-resistant layer thickness of 0.07-0.7mm, the structural design is as follows:

Layer 1 One-layer	PVC wear-resistant layer 0.07-0.7mm PVC Wear-resisting surface 0.07-0.7mm
Layer 2 Two-layer	PVC color film PVC color film
Layer 3 Three-layer	Anti-warp film 9S, Anti-warp film 12S, Anti-warp film 19S (Recommended product) Anti-warp film 9S, Anti-warp film 12S, Anti-warp film 19S(Recommended product)
Layer 4 Four-layer	PVC intermediate material, specific gravity about 2.0, no need for low specific gravity base material to balance, reducing the overall cost. PVC intermediate material, the specific gravity is about 2.0, there is no need for low specific gravity base material to balance and reduce the comprehensive cost.

2. For PVC wear-resistant layer thickness of 0.07-0.7mm, with anti-plasticizer migration to prevent water-based floor adhesive from rotting, the structural design is as follows:

Layer 1 One-layer	PVC wear-resistant layer 0.07-0.7mm PVC Wear-resisting surface 0.07-0.7mm
Layer 2 Two-layer	PVC color film PVC color film
Layer 3 Three-layer	Anti-warp film 9S, Anti-warp film 12S, Anti-warp film 19S (Recommended product) Anti-warp film 9S, Anti-warp film 12S, Anti-warp film 19S(Recommended product)
Layer 4 Four-layer	PVC intermediate material, specific gravity about 2.0, lower requirements for the physical properties of the intermediate material, reducing the overall cost. PVC intermediate material, the specific gravity is about 2.0, there is no need for low specific gravity base material to balance and reduce the comprehensive cost.
Layer 5 Five-layer	Bottom support film 6D, Bottom support film 9D Bottom support film 6D, Bottom support film9D

3. Suitable for online composite LVT, no UV surface treatment required, smoke and scald resistant wear layer, the structural design is as follows:

Layer 1 One-layer	Wear-resisting surface 1918 (Recommended product) Wear-resisting surface 1918(Recommended product)
Layer 2 Two-layer	PVC color film PVC color film
Layer 3 Three-layer	PVC intermediate material, specific gravity about 2.0, no need for low specific gravity base material to balance, reducing the overall cost. PVC intermediate material, the specific gravity is about 2.0, there is no need for low specific gravity base material to balance and reduce the comprehensive cost.